DIY Wireless Charging Pad

Printing Tips

Printing Technology: FDM
Layer Height: 0.2mm
Perimeters: 4
Infill: 10%
Infill Pattern: Gyroid
Recommended Material: TPU for top and bottom cover, PETG or ABS for frame.
Supports: None
Support Type: None

Notes:
Designed as an attempt to create an LED free charging pad, this DIY design requires no screws to assemble.

Disclaimer:
This was tested with charging and had no issues, however, I make no claims about the safety or reliability of this.
Use at your own risk.

Assembly Instructions

Materials Needed:
Dual Coil Wireless Charging Pad

Instructions:
1. Print all pieces
3d printed parts and a wireless charging module

2. Insert coil housing into board housing

3. Slide board through the opening in the board housing.

4. Gently press board into place with USB C side at the opening. Push LED into LED housing.
A circuit board being inserted into a housing

5. Arrange wires so they are on the sides of the coil board and gently press coil board into place.
Wireless charging module being inserted into a housing

6. Insert top cover so vents are on opposite sides of the USB C connector and pin is on the right. Press into place. Repeat for bottom cover.
Cover being placed on a wireless charger

7. Insert feet
Feet being placed on the bottom cover of a wireless charging module

8. Plug in and charge!

Download Links

Legal Disclaimer:

The files provided here are for personal, non-commercial use only. Redistribution, modification, or commercial use is not allowed without prior written consent from Lunar Prototypes.

Model Comments

Comments Section Under Construction

Feel free to submit feedback via the form below

Customize Model

By using the customization software, you agree to our Privacy Policy, Terms of Service, Disclaimer, EULA, and Cookie Policy.